Grab your two boards, one should be wider than the other. Cut both pallet boards to about 16 inches long.
Sand them smooth to remove any splinters or rough spots.
Measure and drill three holes evenly spaced across the middle, or just below the middle of the wider board.Use a drill bit slightly smaller in width than the 3-inch screws you’re using.If you’re unsure of where to drill, place your ball caps on the board to give you a better visual.
Fit the pieces together in an L shape, so the narrow board is sitting on top of the other.
Drill a few pilot holes through the top of the shelf and into the side of the wide board with your drill bit.
Attach the two boards together with screws.
Head to your paint and stain storage shelf to pick out a finish.
Now that our hat rack has a nice finish on it and has had the chance to dry completely, we’re ready to attach our baseballs!
Using your 3″ screws, screw through the back of the board using the pre-drilled holes.Once the screw peeks through the front of the board, place the center of the baseball on the screw – give it a little push to embed the tip of the screw through the leather.
Hold the ball firmly and slowly screw the screw into the ball until it is secure.
Now attach a wall hanger on the backside of the piece.